there is a mesh like slip cover over my coolant hose its fraying on the end .my question is should i trim it or remove it entirely?????????thoughts???

That mesh is for rubbing, basically to prevent something rubbing against it and wearing down the rubber eventually causing a leak. If it's been rubbed through or frayed because of age you could replace it. But it depends on it location as well wether or not it would need replacing.

its just the netting on the outside hose is fine

I took mine off when I went with braided hoses

i may go to braid but for the time being i need it trimmed or taken off for saturdays shows.....

and im pretty sure the hose isnt against alot of other parts

Just take the hose off, trim it and throw a zip tie around it and it won't fray

let me snap a pic

it looks stupid 3/4 coverage and keepfraying when i trim...is it that necessary?

Electrical tape...

Dealer has hose 20 bucks ..i just dropped alot of money on mods i guess another 20 wont kill me.

I put a small black zip tie on the one on the mango can't even notice it and it does the trick

Yea but 3/4 of hose is there it must of shrunk

Yea but 3/4 of hose is there it must of shrunk

yeah it just needs to be slid back up. If you have ever played with Chinese finger cuffs you will know how to do it.
You basically need to push it all the way down and then with it compressed slide it back up. It is hard to explain but it works

Im at work and orderering new hose is there ayone tgat can verify size of upper hose. Please

Just a heads up, if you remove that mesh covering then your car will explode.